DH-1222-1 Load control request for scheduled control
Message DH-1222-1 is of message type F35.
Message payload includes the following information:
Information field | Level | Necessity | Field content | Note |
|---|---|---|---|---|
Payload | 1 | 1..1 |
|
|
Party identification | 2 | 1..1 |
| Identification of the party that made the control request. |
Basic accounting point data | 2 | 1..1 |
|
|
Accounting point identification | 3 | 1..1 |
|
|
End device control request | 2 | 1..1 |
|
|
Request identification | 3 | 1..1 |
| Unique identifier that is referenced in the load control confirmation event. |
Relay identification | 3 | 1..1 |
| Specifies the controlled relay at accounting points with two relays. At accounting points with one relay, value 1 is used. |
Request type | 3 | 1..1 |
|
|
Type | 4 | 1..1 |
|
|
Control period | 3 | 1..7 | Control periods of the scheduled control request | In consecutive control periods, the end time of the previous period must be the same as the start time of the next period. |
Relay state | 4 | 1..1 |
|
|
Start time | 4 | 1..1 |
| Start timestamp of the control period including the time zone |
End time | 4 | 1..1 |
| End timestamp of the control period including the time zone |